up previous next
Probably the best way to run CoCoA under Unix is through the editor
emacs. In that way, one may easily edit or repeat commands.
From within emacs, issue the command
META-x shell. You
will be presented with a Unix prompt within emacs. Change to the
CoCoA directory, and start CoCoA. For more information about
shell-mode, issue the emacs command
Control-h m after the shell is
started. (You may want to use the emacs command:
META-x set-variable comint-scroll-show-maximum-output
to set the variable comint-scroll-show-maximum-output to the value 1.)
If running CoCoA in an xterm, it may be best to first start the xterm
with the command
xterm -sb -sl 512 (scroll bar enabled, saving 512
lines). In addition, you may want to increase the vertical size of
your window, e.g.,
xterm -sb -sl 512 -geometry 80x40. In that way,
output that scrolls off of the screen is captured and easily reviewed.
At any rate, complicated CoCoA command sequences or any sequences that
you may want to repeat should be saved in a text editor. The commands
can then be executed by copying and pasting into a CoCoA window or
using the
Source
command. In addition, you may want to keep a log
of your CoCoA session using the command
OpenLog
.